Layerline Pulse

Bambu Lab print monitor

Layerline
Pulse.

See up to three Bambu Lab printers at once, with print progress, AMS status, temperatures, and alerts.

Open web installer

Firmware · Version 2.0

Install or update

Elecrow CrowPanel 5.0-inch HMI
DIS07050H · ESP32-S3 · 800 × 480

Open this page in desktop Chrome or Edge and connect your CrowPanel with a USB data cable. Close any serial monitor using the port.

Checking browser support…

First install

Use for a new CrowPanel. Replaces the board’s firmware and clears saved settings.

Update Layerline

Use on a CrowPanel already running Layerline. Keeps saved Wi-Fi and your Bambu session.

Troubleshooting

The USB port is missing

Try a different USB data cable and close Arduino Serial Monitor, PlatformIO Monitor, or programs using the port. Windows may need the USB serial driver described in Elecrow’s CrowPanel documentation.

The CrowPanel does not connect

Hold BOOT, press and release RESET, then release BOOT. Retry and choose the CrowPanel port. After a successful upload, press RESET if the board stays in the bootloader.

Configure the touchscreen

Tap the printer count to cycle through one, two, or three printers. Open Settings to choose which readings to show or to change your Wi-Fi or Bambu login.

Confirm your board is the Elecrow CrowPanel 5.0-inch HMI (DIS07050H).